Thermal Fishing Bob Barnraising!!
This is a revision from October 06, 2013 22:17.
View all revisions
We worked on a version of thermal fishing bob described here:
http://publiclab.org/wiki/thermal-fishing-bob
We found there were problems with the circuit diagram shown in this wiki page.
This version uses a 10K Thermistor from Ada Fruit:
http://www.adafruit.com/products/372 It comes with a 1% 10K resistor which you can use as calibration or for a resistor divider
Additional parts: * 1 common-anode RGB LED * wire * a breadboard or circuit board & soldering eqmt. * Arduino * 9v battery and holder
We had some successful tests:
