Public Lab Wiki documentation



555-conductivity-meter

This is a revision from July 12, 2014 21:10. View all revisions
2 | 7 | | #10683

« Back to Open Water

Reposted from Don Blair's earlier note.

Project

This circuit modifies the 555 Blinky LED circuit to blink an LED at a frequency that is inversely proportional to the conductivity of a solution. We built a bunch of them during the 7/12/14 Water Quality Workshop @ MIT Media Lab and tested them out.

Pretty cool stuff!

Diagram

555conductivity-nocap.png

FI66X99H7996R0X.MEDIUM.jpg

How to build it

Salt solution: We used 100 ml water in five different solutions

20140712_160519.jpg

1 - No salt (distilled water) 2 - 100 mg (low salt) 3 - 425 mg (medium salt)
4 - 1100 mg (high salt) 6 - 5000 mg (brine - similar to salt water)

A good explanation of conductivity and salinity

We used this page to compare salinity to real-world samples

20140712_143829.jpg

Water bottle setup: Cut the top off and fill your water bottle to 100 ml

20140712_150326.jpg

Build your sensor Two screws in the cap, roughly 1 cm apart and attached to alligator clips -- this is your sensor and goes in place of R2

Pictures of built sensors

20140712_143049.jpg

20140712_144749.jpg

20140712_143028.jpg

20140712_160313.jpg

Output to Arduino

Here's some Arduino code to monitor the output (more explanation tomorrow), as well as measure the temperature (an important variable for conductivity):

https://gist.github.com/dwblair/f0baedb7b8e155b804ae

A preliminary test showed a nice, solid, repeatable relationship between conductivity and the average 555 timer pulse duration (y axis is average pulse duration in seconds, x axis is index of data points, sampled every few seconds -- the probe was initially placed in a higher conductivity solution, then then briefly in a lower conductivity for three separate stretches (indicated by the three higher plateaus)) ...

conductivityjuly14-2.png

Mods

Tone generator dance machine version - swap output to an audio cable - add a potentiometer to drop the voltage to a safe range for your computer - limit max voltage 0.5V (without no pot the output is 2.8V) - feed it into a tone generator -- make some tunes!

Capacitor swap analog synth version - swap 10uf cap for .01uf cap - add a piezo speaker in parallel with your LED - instead of clicks, you hear distinguishable tones! - one whole step between salinity #4 and #6 -- noticeable difference!

(note: with the smaller capacitor the LED will not blink for either circuit -- it's blinking too fast and looks like it's permanently on)

See also: open water wiki